View Single Post
Old 04-24-2018, 05:36 PM
JMR JMR is offline
Join Date: Feb 2013
Location: STL, MO
Posts: 124

I cleaned it up and put in a new recoil spring the cmp spring had a kink in it.
Also replaced the clip latch spring it looked original with allot of crud under the clip latch.

I stripped the bolt and cleaned it as well. I noticed the firing pin looked like someone had ground on it at the corner of 90 degree bend just in front of where the hammer strikes it. The firing pin floats ok in the bolt without issue.

Has anyone heard of firing pins being worked on like this ?

Last edited by JMR; 04-24-2018 at 05:41 PM.
Reply With Quote