View Single Post
  #1  
Old 10-19-2018, 03:50 PM
remway remway is offline
 
Join Date: Dec 2009
Posts: 46
Default New Help Regarding SAGE DCSB

It's been a couple of years since I shot my Fulton Armory M-14 with SAGE stock, with a Night Force 1-4X scope using the SAGE DCSB.

I took it to the range and set a target at 100 yards. I don't recall exactly what size groups I was getting when I sighted it in 2 years ago, but I do remember being very satisfied with the results. I naturally expected the same results but was surprised with vertical string groups of 4 plus inches! I checked the scope and mount and discovered that grasping the scope I was able to get a small amount of up and down play at the rear base support (stripper clip guide).

Is this the likely cause of my stringing shots pattern? Will re-installation of the DCSB eventually lead to the same problem? Would loc-tite prevent this from happening again?

When I initially installed the DCSB I followed the instructions per: M-14 ENHANCED BATTLE RIFLE (EBR), SUPPLEMENT TO TM 9-1005-223-10.

Any suggestions? Thanks in advance your your replies.
Reply With Quote