View Single Post
  #26  
Old 12-13-2017, 12:53 PM
lemmonhead lemmonhead is offline
 
Join Date: May 2010
Location: Las Vegas, NV
Posts: 272
Default

With a relief cut the barrel comes off pretty easy.
When placing the barrel in a vise, make sure the barrel is in the center of the jaws. I rotated my vise about 60 degrees counter clockwise and placed the barrel in the center of the jaws with the mid part of the barre resting up against the vise. The barrel come off without much force.
If you don't have a mill or lathe then use a safety file to remove the weld as much as possible without getting into the receiver face.
Reply With Quote