View Single Post
  #1  
Old 12-06-2014, 08:49 AM
R6T8net R6T8net is offline
 
Join Date: Feb 2014
Location: NE Ohio
Posts: 372
Default Barrel Vise and Action Wrench

I've got (4) sets of the following for sale:

-Barrel vise (generic)
-M1 carbine bushing set
-Action wrench (generic)
-M1 carbine action block

This started out with me making a setup for myself and decided to make a few extra to see what happens. These are super heavy duty (probably a little overkill) and with normal use will be the last ones you buy.

Garand bushings and action block are in the works and should be done in a week or so. They will directly replace the carbine items.

Bushing will be tight the first time. This was intentional in order to allow them to "seat" to the barrel. Action block was designed for a soft shim (brass, copper, etc.) and screw to tighten against receiver to make up for any mfg. tolerance of receiver.

Due to the "not so great" knurl on the handle (the only machining I did not personally do; go figure) and the fact that these constitute my my initial run I'll let the first (4) sets go for $125 each plus shipping. Garand parts will be an extra
$50 if ordered later but if paid up front $30.00 shipped for whoever buys the kit.

[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]
Reply With Quote