View Single Post
  #6  
Old 03-13-2018, 07:59 PM
Bayou Bayou is offline
 
Join Date: May 2012
Location: SE Louisiana
Posts: 347
Default

Quote:
Originally Posted by sigman2 View Post
Try putting the cutter in the chuck. You won't have to keep turning the motor off and on. If your cutter is too large purchase one of the ball grip cutters which has a smaller diameter cutter. Just remove the cutter from the ball and chuck it in the drill press.
I've never tried that technique before. Question - if the cutter is chucked in the drill, what do you use to hold the case tight against the cutter while it is being trimmed? Is finger pressure sufficient or is something needed to hold the case tight so the cutter doesn't turn
the case while it's being trimmed?

Thanks!

Bayou
__________________
Bayou
NRA Life Member
Reply With Quote