View Single Post
  #5  
Old 12-13-2019, 09:52 AM
M14 M14 is offline
 
Join Date: Jul 2011
Location: south mississippi
Posts: 824
Default

Quote:
Originally Posted by k98dave View Post
After about 25 rounds I noticed groups stated opening up somewhat. Thought rear sight was moving but upon closer look found that trigger guard had popped open about 1/8". Gave it a good smack and it snapped back into fully closed. A few days later with about the same amount of shooting it did it again. This is a factory bedded receiver/trigger group NM by S/N approx 2002 mfg. Anyone ever experience this? Suggestions?

Thanks
Hi Dave, when Bula first came out with their trigger groups, I ran into a couple that had this problem. The trigger guard bend and angle were off compared to the g.i. ones when laid beside each other.

My fix was to get the bend or curve in the guard to match, then heat it in the oven at 400 degrees for 50 minutes, take it out and let cool naturally in the air, then run another cycle in the oven at 350 degrees for 40 minutes, and it will take the set you put into it and stop coming loose.....providing of course, that you checked the area that RDS mentioned, and no wood or bedding are interfering.
Reply With Quote