Go Back   CMP Forums > Welcome Center > How To's
Register FAQ Members List Calendar Mark Forums Read

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-29-2011, 08:55 AM
Orlando Orlando is offline
Join Date: Oct 2009
Location: Ohio
Posts: 9,970
Default How To: Reworking CMP/Dupage/Boyds M1 Garand Stocks

There has been questions about the fit of commercial stocks lately so I thought I would post my findings
In my opinion all Boyds/Dupage/CMP stocks need "some" work. Some more than others. Here are a few things I have found that need checked
You need to check the width of the barrel channel. If it is to narrow it will hold the barrel up and result in your rifle shooting high. You can see that I releived both sides of the channel in the picture
I also had a problem with the stock ferrule setting to high and the Op Rod rubbed on it.
I carved out some of the wood with a utility knife until it set in the proper position.

Problem solved? Not yet, I then had to fill in the area on the bottom since the ferrule set lower so it would stay in place when tightened
I taped off the stock, and applied paste wax to the ferrule for a release.
Then placed JB Weld to the bottom of where the ferrule sets on the stock, put ferrule in place and start to tighten the screw but not all they way
"I am the master of my unspoken words, and a slave to those that should have remained unspoken. ...
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 10:49 PM.