Go Back   CMP Forums > CMP Sales > CMP Bolt Action Rifles
Register FAQ Members List Calendar Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 09-22-2019, 11:03 AM
TFLeader TFLeader is offline
 
Join Date: Jul 2011
Location: MA
Posts: 180
Default Removing 1903 rear sight sleeve?

Picked up a 1903 drill rifle. Got it all apart but canít figure out how to remove the rear sight barrel sleeve? Donít see an obvious pin. Barrel date is 1918. How hard is/was it pressed on? Have a lead on a replacement barrel, but needs the sight sleeve. Any suggestions would be greatly appreciated!
Reply With Quote
  #2  
Old 09-22-2019, 01:28 PM
navyrifleman navyrifleman is offline
 
Join Date: Oct 2009
Posts: 359
Default

This same subject was discussed on another thread recently.

Basically, you should remove the barrel from the receiver first. This will probably require some grinding on the tack weld before you put it in the barrel vise and wrench tool assembly (available from CMP).

The rear sight collar is pinned in two places. One pin is inserted on the bottom of the collar at a 90 degree angle to the barrel. You might notice some grinder marks which were parked or blued over where the ends of the pin were ground down. The second pin is on the right side of the barrel and is in line with the barrel between the barrel and the collar. You can only see it when the barrel has been removed.

Remove the forward pin with a pin punch, then use a piece of pipe or socket large enough to miss the barrel, but contact the sight collar. Drive the whole collar forward by striking the pipe/socket with a mallet.

Note, some drill rifles have holes burned through the collar which welds it to the barrel. Be sure to do some grinding on that "wound" before attempting to drive the sight collar forward.

The sight collar is relatively soft metal and if you attempt to drive it off using a wooden or metal piece (like a screwdriver) you will damage it and the sight won't fit into it.

Last edited by navyrifleman; 09-22-2019 at 01:30 PM.
Reply With Quote
  #3  
Old 09-22-2019, 03:02 PM
TFLeader TFLeader is offline
 
Join Date: Jul 2011
Location: MA
Posts: 180
Default

Mission accomplished!

Thanks for the assistance.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 07:29 AM.