Go Back   CMP Forums > CMP Sales > CMP Bolt Action Rifles > Mann Accuracy Device
Register FAQ Members List Calendar Mark Forums Read

Reply
 
Thread Tools Display Modes
  #1  
Old 11-16-2012, 03:30 PM
Cowboysnavy Cowboysnavy is offline
 
Join Date: Oct 2012
Location: SE GA
Posts: 69
Default Solved feeding problem

The problem with feeding is the extractor it isn't wide enough to feed the 7.62x51 properly the 30-06 is only slightly different. If you pull your bolt out and hold the extractor stiff like it is in your receiver you will see that it has to flex a lot to allow the 7.62 cartridge to feed into it. If you clearance Where the extractor is cut slightly inward on a few thousands .003-.004" it will feed like butter I wish I could show photos but no camera.
I found this out when feeding a snap cap it feed so clean I took a few measurements and found the base of the snap cap was .005" smaller than my 7.62.
Reply With Quote
  #2  
Old 11-17-2012, 07:09 PM
kraigwy kraigwy is offline
 
Join Date: Jun 2010
Location: NE Wyoming
Posts: 1,078
Default

Good to know for when I get my 1903 308 Mann.

The one I have now is a Rem 700 5.56 Mann, which is a bit different as it feeds better from the mag. then it does single loading like the 1903 Mann's.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 12:17 AM.