Go Back   CMP Forums > CMP General > Ask Each Other
Register FAQ Members List Calendar Mark Forums Read

Reply
 
Thread Tools Display Modes
  #31  
Old 03-17-2018, 10:07 PM
becquette becquette is offline
 
Join Date: Mar 2015
Location: Utah
Posts: 345
Default

I finally took an inside measurement of the gas cylinder.
Top to bottom I measured 0.531
Side to side I measured several time to make sure 0.5325, which is out of spec.
Using a pin gauge of 0.532 would not have passed through the cylinder.
However due to the side to side measurement, gas is escaping causing short cycling.
The op rod had a button of .5265
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -5. The time now is 06:53 AM.