View Single Post
  #15  
Old 10-13-2021, 04:31 PM
d.swider777 d.swider777 is offline
 
Join Date: Feb 2019
Location: PA
Posts: 287
Default

Quote:
Originally Posted by sparx View Post
Here are images of a CMP stock set I did up recently using a different procedure than my normal. This walnut set did NOT have the exterior sanded or stripped. I only addressed the sharp edges of the wood, lightly sanding them. Then, I rubbed the entire exterior down with a purple Scotch Pad. All standard internal fitting procedures were done as usual.


After rubbing the wood down I applied about 4 coats of BLO and you can see the results. It turned out very nice, but all Boyds cross grain sanding issues still remain, in this case there were not too many.


Sparx














Sparx did you put anything on the purple scotch pad when you wiped it down or did you just do it dry? It looks really nice! How did you apply to BLO?
Reply With Quote