Thread: H&r m12
View Single Post
  #4  
Old 04-15-2021, 11:39 PM
broomhandle broomhandle is offline
 
Join Date: Feb 2016
Location: Augusta GA- X NYC guy
Posts: 904
Default

Hi Sir,

DO not even think about taking the bolt apart without reading how to do it!
It's a complex unit. You might ruin it for a minor problem.
This is a great place to find out how to do it correctly. Ask here or the How TO section of the board.
I had a issue with the extractors, a fellow replied & the minor problem was fixed in a flash. I did not see or feel the Dried grease in extractor slots. A good soaking in some solvent was the fix!

Good Luck.
broom
Reply With Quote