Thread: H&r m12
View Single Post
  #5  
Old 04-16-2021, 12:08 AM
Calfed Calfed is offline
 
Join Date: Dec 2009
Location: California
Posts: 1,814
Default

Quote:
Originally Posted by broomhandle View Post
Hi Sir,

DO not even think about taking the bolt apart without reading how to do it!
It's a complex unit. You might ruin it for a minor problem.
This is a great place to find out how to do it correctly. Ask here or the How TO section of the board.
I had a issue with the extractors, a fellow replied & the minor problem was fixed in a flash. I did not see or feel the Dried grease in extractor slots. A good soaking in some solvent was the fix!

Good Luck.
broom

I appreciate the tip. I'm not sure what the problem is, but I will approach fixing it with caution.
Reply With Quote