Thread: IHC Drill Rifle
View Single Post
  #2  
Old 07-16-2018, 02:42 PM
Mike in NC Mike in NC is offline
 
Join Date: Oct 2009
Location: NC
Posts: 2,896
Send a message via AIM to Mike in NC
Default

The front of the bolt face was welded. The chamber of the barrel was welded full. I would be concerned about how much heat went into the front of the receiver when that barrel chamber was welded shut. In my book, that is a lot different that a small tack weld between the barrel and the receiver.

Without any additional pictures is it hard to tell how much might be welded.
Reply With Quote