Go Back   CMP Forums > Welcome Center > Test Forum
Register FAQ Members List Calendar Mark Forums Read

Thread Tools Display Modes
Old 06-18-2022, 04:36 PM
SgtMike SgtMike is offline
Join Date: Nov 2014
Location: Southern Calif
Posts: 29
Default Next Up

Up for sale is an M1 Kit, all the necessary parts that are required for assembling a Garand. All that is needed is a Garand receiver.

Stock - New CMP Boyd's stock with upper and lower handguards and all metal

Lower Band - Type 5, IHC or HRA with Roll pin

Barrel - Springfield SA 6535448 11 64 Y63, No Gauges, See photos for bullet in barrel

Gas Cylinder - Springfield, Narrow sight base, Beveled Gas Cylinder Lock, Gas Cylinder Lock Screw - Repro, Rear Barrel Ring "7" on top

Trigger Housing - D28290-12-SA
Hammer - C46008-5 SA
Trigger Guard - Stamped - Mfr ?, Stamped Hook, Centered punch marks both pinions
Safety - SA_11
Trigger - "S" visible in forging, single hole, Type 2
Plunger - No wings

Operating Rod - D35382 9-SA, Piston - 0.525" Modified

Follower Rod Assy - Type 4, Stamped & Riveted, Short Fork

Bolt - D28287-19SA, A-8

Rear Sight - Springfield, T105E1, Elevation Knob marked SA, Windage Knob marked IHC DRC

Op Rod Catch - Type 2, Mfr ?
Clip Latch - Springfield, Type 2, No Markings
Follower Arm - Springfield Type 3, Forge Number "2S" visible on side
Follower & Slide Assy - Springfield Type 2, No Markings
Bullet Guide - Springfield Type 5, Stamped

Photos - https://imgur.com/a/uE0SHlv

Asking $750.00 Shipped. Payment USPS Money Order or Personal Check - Held until cleared.

The first to post an I will take it, followed with a PM gets it.

Last edited by SgtMike; 06-18-2022 at 05:37 PM.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 06:21 AM.